Sensitive equipment needs protection, and since 1976 the answer has been the Peli™ Protector Case. These cases are designed rugged, and travel the harshest environments on earth. Against the extreme cold of the arctic or the heat of battle, Peli cases have survived.
Made in the USA, these tough cases are designed with an automatic purge valve, that equalizes air pressure, a watertight silicone O-ring lid, over-molded rubber handles and stainless steel hardware.
Configurations:
1170 Protector Case
The No Foam (1170NF) configuration includes:
- 1170 Protector Case
1170 Protector Case
The With Foam (1170WF) configuration includes:
- 1170 Protector Case
- Foam Layers
- Foam Layer 1 (Lid) - 2.8 cm Convolute
- Foam Layer 2 (Base) - 3.8 cm Pick N Pluck (.50" x .50" squares)
- Foam Layer 3 (Base) - 1.3 cm Solid
- The hand-held electronics protection solution
- Pick N Pluck™ with convoluted lid foam
- Watertight, crushproof, and dustproof
- Open cell core with solid wall design - strong, light weight
- Easy open double-throw latches
- Automatic pressure equalization valve - balances interior pressure, keeps water out
- Peli's legendary lifetime guarantee**
- O-ring seal
- * Where applicable by law
YOU MAY ALSO LIKE
SPECIFICATIONS
Dimensions
Interior (L×W×D)
26.8 x 15.3 x 8 cm
Exterior (L×W×D)
29.6 x 21.2 x 9.6 cm
Measurements
Lid Depth
2.7 cm
Bottom Depth
5.3 cm
Total Depth
8 cm
Int Volume
0.003 m³
Weights
Weight With Foam
1 kg
Weight Empty
0.9 kg
Buoyancy
3.3 kg
Materials
Body Material
Polypropylene
Latch Material
ABS
O-Ring Material
Polymer
Pins Material
Stainless Steel
Foam Material
Polyurethane
Purge Body Material
ABS
Purge Vent Material
3 Micron Hydrophobic Non-Woven
Temperatures
Minimum Temperature
-40° F (-40 ° C)
Maximum Temperature
210° F (99 ° C)
Approvals
Certifications
IP67
